backpack light with remote switch

backpack in the light
backpack in the light
backpack in the dark
backpack in the dark

I ride my bike to work on main roads year around, so I need to be visible. In the winter that means lights. If I attach them to the bike, I have to remember to take them off, and they are relatively low to the road and less visible. I had them on my helmet for a while, but that was heavy. So, I have them on my backpack.

This has worked well for some time, but I usually put on my backpack and then remember that I did not turn them on. Then I have to take the pack back off and switch them on. So, I added a remote switch to the EL driver where its

EL driver with plug attached
EL driver with plug attached

internal switch is attached. Because I wanted to still be able to disconnect the driver, I wanted a plug connection. All I had flying around was an old USB port and plenty of USB cables to salvage, so that’s what I did. Ya, I labelled it “NOT USB”.

I made the remote switch by wiring a scavenged

switch soldered right onto the cable
switch soldered right onto the cable

momentary switch right into the end of the wire and putting heat shrink tubing around it. The tubing waterproofs the setup and is flexible enough to trigger the switch.

Then I fed it around the backpack straps.

remote switch on backpack strap
remote switch on backpack strap

 

Leave a Reply

Your email address will not be published. Required fields are marked *